DSH 590 Rule for creepage across grooves and similar surface discontinuities
http://decisions.iecee.org/icons/ecblank.gif DSH 590
Rule for creepage across grooves and similar surface discontinuities
IEC60664-1: 1992 cl. 4.2 IEC60335-1: 1991 Annex E IEC60335-1: 2001 Cl. 29 IEC60730-1: 1999 Annex B IEC60950: 1999 Annex F IEC60950-1: 2001 Annex F IEC60065: 2005 Annex E IEC61010-1: 2002 Annex C IEC60601-1: 1988 Notes Figs 39-47 IEC61558-1: 1988 Annex A IEC61058-1: 2000 Annex A IEC60598-1: 2003 - IEC60745-1: 2001 Annex A IEC61008-1: 2002 Annex B IEC60947-1: 2004 Annex G
60335-1(ed.4) & 61058-1(ed.3) & 60598-1(ed.6) & 61010-1(ed.2) & 60950-1(ed.1) & 60947-1(ed.4) & 61008-1(ed.2);am1 & 60065(ed.7);am1 & 60664-1(ed.1)
Question:
As can be seen from examples 2 and 6 of IEC 60664-1 sub clause 4.2 corners with angles greater or equal than 90 degrees are not bridged. IEC 60664-1 does not contain specific information at which angle less than 90 degrees bridging
shall be applied. Some of the above mentioned standards specify that bridging shall be applied for angles less than 80 degrees.
Can this 80 degree rule be applied in general for all standards?
Decision:
Yes. The 80 degree rule shall be applied in general for all standards.
页:
[1]
