DSH 636 Resistance to heat and fire
DSH 636
Resistance to heat and fire
30.2.2 and 30.2.3
60335-1(ed.4)
Question:
In the photographs included below, a construction is shown with material not resistant to the glow wire test at 750ºC/850ºC marked PP and a terminal block mounted on 3 pins moulded on the material. In order to separate the connection area from the plastic part PP, a piece of a different material has been interposed. The pins fixing the terminal block are still made of material PP and are within a distance of less than 3 mm. Should material PP in this construction be tested with glow wire test at 750ºC/850ºC?
Decision:
The material shall be tested if it is less 3 mm from the connection. The 3 mm distance has to be measured from the point of connection between the wire and the screw inside the terminal and not from other terminal part.
页:
[1]
