DSH 582 Supply protection characteristics during abnormal operation

小米

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

DSH 582

Supply protection characteristics during abnormal operation ) m5 c6 q' R$ F$ d

H27.1.2 and H27.1.3 3 J( n( t$ a( u

60730-1(ed.3);am1

Question:
8 ]3 j: E3 G' _4 QSub-clause H27.1.2 item d) prescribes that for abnormal operation the electrical supply shall have a fuse rating such that the result of the test is not influenced by the operation of the fuse. The evaluation of compliance given in sub-clause H27.1.3 item f) states that “A fuse in the supply, external to the control under test and as described in item d) of H27.1.2, shall not rupture unless an internal protective device also operates that is accessible only after the use of a tool”.
& K' h. S# f8 [1) There is an apparently inconsistency between H27.1.2 and H27.1.3. On one hand the fuse shall have such characteristics (e.g. high rated current or rated short-circuit capacity) in order to not limit the effects of the test; in the other the operation of the fuse is considered as a test failure. Which criteria shall be followed during the selection of the fuse.
2) The use of fuse as protective device in the fixed wiring is not a common practice in several countries. Is it accepted the use of other protective devices such as circuit breakers?
3 ^' Y) h& \% ]  I7 Q: S, |! X, N% k/ FDecision:
" G6 q) Y, _4 w/ VIt was agreed that the intent of Clauses H.27.1.2 and H.27.1.3 is that the size of the supply fuse be large enough so that it allows the Equipment Under Test (EUT) to see the most onerous conditions (note that the “fuse in the supply” referenced in Clause H.27.1.3.f is the same fuse described in Clause H.27.1.2.d). That is, the EUT should be tested without the supply fuse opening. In this way, faults introduced to the EUT stress the EUT and its inherent protection (if any) without the EUT becoming protected by opening of the supply fuse



% |, j. v$ }" c) c1 k