|
| DSH 650
% u" F% ^" I: I& a
2 U3 b% I) g1 T3 F& E2 s | Definitions
8 f5 r5 q6 G# o ? | 3.1.92 r# J" ?8 M& ?& V
| 60335-2-55(ed.3)9 J- g6 _1 B( g/ U7 a
| 3 I; n: @) r+ a5 J
Question:' m' H5 [) v" ^$ [
As stated in the 5th paragraph of clause 3.1.9 of IEC50335-2-55, "Heaters are operated in a sufficient quantity of water to maintain the water temperature between 20ºC and 25ºC without the thermostat cycling." In the case of a heater in which the thermostat cycles independently of its regulation and of the water temperature, the above test conditions will not be possible to obtain.3 U4 v2 r3 L& u0 J$ H, b4 N1 T
(1) Is the heater not complying to the standard because it does not reach the standard operating conditions?
% t6 T/ {8 e3 f( z& w6 P# LIs the test (clause 11) performed in the most unfavourable condition and the standard applied accordingly?
2 ]. r! P3 v9 [( dRationale: see question
4 m, h" p' l( sDecision:
2 w) E8 j. C" ]2 D% pIf there is any kind of temperature sensing for cycling, then it should be prevented from cycling per clause 11. Sub-clause 19.4 may be covered in this construction. But if the cycling does not rely on the temperature of the water (energy regulator or similar) the cycling means are allowed to operate in clause 11 and shall be short-circuited in sub-clause 19.4.
( ]) Y- I. ]+ ^" }9 z" l8 h
* C0 f9 f H1 ~, k7 s; g% v
1 b( s9 e, J7 F' p: X |
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?注册安规
x
|