|
哥,请先说出哪边的撒,根据IEC 60335-2-91:2008 如下要求; _2 B: r! Z8 P1 \. N+ M* y
20.101.1 Lawn trimmers: l8 a( x g/ p
Lawn trimmers shall be guarded on the operator’s side, as a minimum, to the extent shown
5 {! l! }( C( lin Figure 101.7 e l7 E: I& i7 u6 A+ J
The radius X of the guard shall not be smaller than the major swept radius of the cutting
+ ]# V/ V/ E2 x- U- R1 c# ~9 {# uhead and the guard shall extend beyond the plane of the cutting element by at least 3 mm
/ l2 C, {( C9 F, Q" E* D0 m: u' r" _for walk-behind lawn trimmers and 10 mm for hand-held lawn trimmers. The guard shall
7 o: O- R7 ?$ K7 w0 Nextend at least 45° from the axis of the handle on the side where the cutting element is! |" N6 A6 C, `( L
moving away from the operator and at least 90° from the axis of the handle on the side where
* D' p1 i- ?8 Z) kthe cutting element is moving towards the operator. The vertices of these angles lie on the$ l# g# K8 a5 p8 C
axis of the cutting head spindle.! P6 \ z5 |6 q! {% c) i
If the guarding is less than a total of 360°, the direction of rotation of the cutting element(s)
2 D/ O: p# Z" d+ e% \ wshall be marked on the lawn trimmer.1 @9 q0 q( H- H9 Z, `4 o1 |
Compliance is checked by inspection and measurement.
" W- t5 Y; R' _1 m' C4 c/ h& I8 r20.101.2 Lawn edge trimmers+ Z2 i' c7 O9 c f/ v, J( |5 _
Lawn edge trimmers shall be guarded, as a minimum, to the extent shown in Figure 102.
6 x$ B* B) y& ^' \4 }The radius X of the guard shall not be smaller than the major swept radius of the cutting
- n3 R. [" ?% @head. The guard shall extend beyond the plane of the cutting element by at least 10 mm.
# x, @7 z" s( M9 c8 d2 g) \With the lawn edge trimmer in its normal position of use, the guard shall extend a minimum
; a' k5 M% U; R) U# x, rof 90° from the vertical towards the ground on the side where the cutting element is moving
0 k; l6 ^* L6 c) u/ m3 Zupwards and a minimum of 45° from the vertical towards the ground on the side where the
4 e Q8 Z2 M5 C5 b7 I+ H1 Tcutting element is moving downwards. The vertices of these angles lie on the axis of the
9 N( d- U3 z) \3 r3 U6 {# y0 B" Zcutting head spindle.+ n' W8 y; q6 `+ j4 S* |
If the guarding is less than a total of 360°, the direction of rotation of the cutting elements
& D+ H5 C. r$ eshall be marked on the lawn edge trimmer. |
|