|
根据EN60335-1中标准的原话:& P3 R2 D3 u8 y; Z- T* Q. W
19.11.4 Appliances having a switch with an off position obtained by electronic
$ G# r: l4 _4 U9 } gdisconnection, or a switch that can be placed in the stand-by mode, are subjected to the tests# J! ?; B$ S5 d! i. A9 o% I: e8 `
of 19.11.4.1 to 19.11.4.7. The tests are carried out with the appliance supplied at rated6 C/ s4 W8 }2 O- w' e+ m
voltage, the switch being set in the off position or in the stand-by mode.
5 ~) V5 k" N) a) C/ l' c2 kAppliances incorporating a protective electronic circuit are subjected to the tests of
: B: G3 }. s, h# _: u" e19.11.4.1 to 19.11.4.7. The tests are carried out after the protective electronic circuit has
1 w- Q3 E/ v/ B/ Ioperated during the relevant tests of Clause 19 except 19.2, 19.6 and 19.11.3. However,* ?/ \5 ~' k2 s& C7 U6 a4 {
appliances that are operated for 30 s or 5 min during the test of 19.7 are not subjected to the1 K: X% z& s/ p' w
tests for electromagnetic phenomena.# k) y4 [$ |1 w4 J" \2 b+ i$ K
The tests are carried out with surge arresters disconnected, unless they incorporate spark gaps.
# P3 ?7 i% j6 j6 rNOTE 1 If the appliance has several modes of operation, the tests are carried out with the appliance operating in each mode, if necessary.
% [" c8 D0 J% A$ u+ v {NOTE 2 Appliances incorporating electronic controls complying with the IEC 60730 series are not exempt from the tests.
7 ~: y+ v3 x* I H. \0 i$ `1 y5 V
而19.11.4.1 到 19.11.4.7.分别是做IEC61000的测试,其中就有-4-2和-4-5的雷击测试。是针对所有待机类产品的附加测试,测试的时候需要拆除压敏电阻,除非与之有相关联的放电管。 |
|