UL 817 Retention of Blades Test Question

vernal.meng

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

' a7 }# l  c  w% n' I% q. \  v# ]引用UL 817

8 K6 k$ O# ^7 d6 h2 u7.4.3.3 The standard test gauge shall be configured as shown in Table 23 using the line blades without holes and with the grounding pin removed. The gauge shall then be inserted in the connector and a static13 N (3 lbf) (including the weight of the gauge), which tends to remove the gauge from the connector, shall be applied for a period of 1 minute in a direction normal to the plane of the face of the connector. There shall not be more than 2 mm (0.08 in) displacement of the gauge. If the construction will accept both the 15 A and 20 A configurations, then 3 units of each shall be tested. If the construction will accept only the 20 A configuration, then 6 units of each shall be tested.
7.4.3.4 The standard test gauge shall be configured as shown in Table 24 using the line blades with holes in the end and with the grounding pin in place. The 1-15R device shall be tested with the 1-15P test gauge without a grounding pin. The gauge shall then be inserted in the connector and a force applied in a direction normal to the plane of the face of the connector that tends to remove the gauge. The static force required to withdraw the gauge shall not exceed 67 N (15 lbf) (including the weight of the gauge).
' B* I5 y0 x, ]7 P: q
. q+ X- ]; r/ H: m& G

对象：在作完过载测试和温升测试后，结构为1-15R, 5-15R, 5-20R, 6-15R 或 6-20R的连接器，还要作本节的插头保持力 测试 .

方法:

  a.以3lbf(13N)的力施加在插头上,保持1分钟，插头位移不得超过0.079inch(2mm).               

b.作完a项测试后,将力增加到15lbf(67N),应可以将插头拔出.

問題1:標準GAUAGE不要帶Grounding Pin 嗎？

+ W' S2 r4 u1 R3 O6 A5 q

H-RH

标准上的描述的确是这样!

vernal.meng

最終的答案應該就是：1-15R與5-15R區別為：2PIN VS 3 PIN
如插頭規為：3PIN
測量2PIN的力值時,需取掉地線PIN