|
head0819 发表于 2016-11-16 11:43 ( \0 C% `2 F7 d7 Q- i
你把标准截图上来啊!
' ^1 f1 ^: K; ` ^ {5 ]41 Test for Limited-Voltage/Current Circuit Transformers
& Y+ p3 R1 U/ i# w/ D [41.1 A transformer intended to power a limited-voltage/current circuit shall be tested as described in 41.2.) H0 l. [0 h$ [# p4 F( W9 P4 R: \
41.2 The maximum volt-ampere output capacity of the secondary winding is to be determined as follows:7 Q6 e' m8 }, G8 Q2 s: [
At room temperature, the primary winding of the transformer is to be connected as intended in the
9 r) Y1 {- c1 u1 @( Q0 _- `* Zequipment and the secondary winding in question is to be connected to a variable resistance load. When$ c$ F8 s# }1 Y7 M2 ?; p+ ?
a fixed-series impedance or regulator circuit is relied upon to limit the output, that impedance or regulator
, d. N; J2 N- a6 Ccircuit is to be included in the circuit during the test. A multiple-winding transformer is to have one- `8 L9 e4 o, _" v. t
secondary winding tested with all other secondary windings open-circuited, and is to be allowed to cool to2 L; Y N* J m9 g' p/ p& o% ~
room temperature again before another winding is tested. A primary winding is to be connected to a
% b' q/ ~% J: @1 r( Vsource of rated voltage. The load on the secondary is to be varied in 10 increments from open-circuit to9 n: n" e( W- ]! p
short-circuit condition in 2-1/2 minutes. For each step or increment in the resistance, the product of the' c( `9 U! Z3 Z( F; ?
output voltage and current is to be recorded, plotted, and run as a smooth curve. The peak value obtained
0 q8 {' H" P) d7 T% |6 P% J5 Hfrom the curve shall not exceed the volt-ampere value specified in Table 27.1. When two or more
7 V# Z" A8 _! p, I2 Y: k4 s' e8 E- Isecondary windings supply interconnected circuits, the sum of the outputs of the windings in question shall% I1 b) K# p! F; R" R: w. t
not exceed the values specified in Table 27.1.
! C5 F2 E* U" f7 E. `& m2 S2 F0 S# {0 o
做舞台灯的大部分都在广州及花都,2010-2012年间有多少家的舞台灯具被我拆的七零八落呢? |
|