|
Appliances are deemed to comply in the frequency range from 300 MHz to 1 000 MHz if
# [& S# }/ @" ^ V, \% q$ Xboth of the following conditions ( 1) and 2)) are fulfilled:
7 [+ X7 B6 C' ?6 w1) all emission readings from the equipment under test shall be lower than the applicable" y J G' _5 N1 c/ y/ \0 b8 e
limits (Table 2a) reduced by the margin (Table 2b);
t! K0 }: Y5 _5 u1 U; @2) the maximum clock frequency shall be less than 30 MHz.7 i. v! N/ |9 ~% z
If either of condition 1) or 2) is not fulfilled, radiated measurements in the frequency range
* f6 g/ q+ B. ]from 300 MHz to 1 000 MHz shall be conducted and the limits of Table 3 for that range
5 z3 E% p6 q- S* X( r- Papplied. In any case the limits of Table 2a in the frequency range 30 MHz to 300 MHz# c5 O3 Y2 Z5 l @
shall be met.
1 _3 y! Y+ W- XTable 2b – Margin when performing disturbance power measurement in the frequency range 30 MHz to 300 MHz
3 i6 F4 V% d! U' G" y& T" BFrequency range Quasi-peak dB (pW) }* L! M# D6 J2 o
200 to 300 0 to 10 dB -
( n$ V, z2 V+ Z! @4 r1 @6 d当功率骚扰(DP)200到300MHzQP余量小于10dB时,辐射(RE)是需要测试的。参见CISPR14-1 2009 |
|