|
6 y+ [2 L2 T3 r$ g& uK.1 Scope0 ~, x5 h+ Z9 p( d. d" O
This annex applies to rechargeable battery-powered motor-operated or magnetically driven
7 E& E* q/ a* Ltools and the battery packs for such tools. This annex applies to tools incorporating detachable,
5 [+ e" F$ b$ b9 H9 pintegral and separable battery packs. The maximum rated voltage for tools and battery packs is) u" e- l& _ G$ a9 w( m0 m
75 V d.c.& g9 Q( {6 i: ~7 Q9 x* _, {
Battery tools covered by this annex are not considered to be class I, class II, or class III tools v# g% M& }% t
and therefore are not required to have basic, supplementary or reinforced insulation. Electric B. K& m) l( x& \" Z+ P
shock hazard is considered to exist only between parts of opposite polarity.% O! m- [; z* F
Battery packs for tools covered under this annex intended to be charged by a non-isolated
9 p9 ]! O- Q1 t5 R9 fcharger shall be evaluated by this annex and standard. When evaluating a battery pack for# w$ |' k4 y* v$ f
protection against electric shock, creepage distances, clearances and distances through5 X/ A# A2 ^4 V, o7 n( y
insulation, the battery pack shall be fitted to the intended charger.3 z9 p7 K" p) m( y8 f! r
All clauses of this standard apply unless otherwise specified in this annex. If a clause is stated
5 B) S+ o; w" H$ x5 pin the annex, the requirements replace the requirements of the standard.. D/ _. X0 f3 |
For the purpose of the tools covered by this annex, the term “mains switch” as it appears in the
3 s" D6 f; P0 Bstandard is understood to refer to the power switch of the battery-operated tool.6 N, r8 b( Y& ^( M/ v) w0 O8 l# V" [
This annex is not intended to apply to tools using general purpose batteries installed by the
7 r0 N% \( p! {! b2 euser, and this annex alone will not be sufficient to ensure all hazards are considered for these# n$ B: _8 ^9 i/ c4 u
products’ “battery packs” .
. A6 `* x! L3 cThis annex does not apply to battery chargers which are covered by IEC 60335-2-29.
4 s% f2 l6 L, K8 _& q
都來看看, 尚有疑問, 有時間再談! |
|