|
|
7.1.1 Where there is sufficient space as defined in 7.1.2, each FMIC shall be plainly and permanently) N7 t$ r: B( P# p t3 c$ s
marked, such as by etching, printing, solder mask marking, or nonconductive ink printing or screening,
4 l" a- O; |- x! Q& `1 }with the manufacturer’s name, trademark, or authorized initials or symbols by which the organization
. a# c2 r, k/ [2 rresponsible for the FMIC shall be identified, followed by a Type designation, or code number or equivalent5 n' Z* k, C" B6 A! z0 N4 E
designation to indicate the FMIC has been tested for flammability, and where applicable, a combination of7 z7 Z+ F1 ?9 Y- p' [5 ^
bond strength, conductive paste adhesion, plating adhesion, cover material, (ambient) bend, cold-bend,
- i) z% d. n4 a \ Rand repeated flexing. Conductive markings, such as etched copper, shall be considered as electrical
0 h/ ?4 S& @# m4 velements (unconnected conductive part) of the circuit and shall not reduce the electrical spacing
9 d# Y8 {+ q6 i3 t. I( c5 O$ K, P, Urequirements for the end product.7 H' {6 l" Z) r- l5 ~# n
* } O: p2 B( R1 y$ s7.1.2 Sufficient space is defined as a space at least 2.5 mm (0.1 inch) high and of sufficient length to accommodate the marking. When there is insufficient space to accommodate the marking, the marking shall be marked on the smallest unit container. The marking may be marked on the panel frame to which the FMIC is attached, if the FMIC will remain in the panel construction when shipped to the OEM.# I; P$ n4 b9 l# ?& Y
. p! b. c8 r/ ?5 o; @& [
7.1.2很关键。
& `) Q4 N/ s) ~6 `9 o' _4 k# c1 C. _ |
|
/2 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 ) 
窥视卡
雷达卡
发表于 2012-3-27 09:43
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
发表于 2012-3-27 12:24
楼主